Yes. There are several I’ve seen advertised but I’ve never used. Pcbway, despite the name, has 3d printing services. I have no experience with them.

I don’t like curves in 3d prints, generally. They’re all chamfered. The original has some curves.

I did try a brim. It was a huge hassle to remove. I don’t mind brims on larger, simple parts, but on these smaller, intricate ones, it sucks.

I swear I posted it! What the heck.

You are insufferable, why are you even here? Never mind I won’t read your answer.

Pressure switch in the bottom maybe?

Do you actually wanna discuss this or do you just want to rant at people like a jerk? I’ll gladly discuss it calmly but you’re being a total jerk.

Bloop bloop bloop.

Why does that turtle have the remote?

Haha thanks.

Not my model, so I can’t say. I do agree that the point should be a little more rounded.

De label them as you go? Not a bad idea.

Ive tried oxi clean and it works but it destroys my hands and needs rinsing off. I like baking soda. It’s weaker and gets consumed faster but it’s easier on my hands and cheap.

Valid question. As others have said, it’s for change ability. I do write in sharpie on the box for the box capacity and contents. However, I have 3 or 4 of these boxes and I swap around the stuff in them a lot. It’s always bottles but sometimes the box is full, sometimes not. Some bottles are ready, some need de labeling. This way I know at a glance what the status of my inventory is.

I have considered swing tops but I have trouble believing that they’d hold well enough. I bottle because I don’t drink much or quickly and I want to give away stuff.

Have you used swing tops? Can you recommend them? I have some from another brewer but haven’t tried them. I could try a few next batch.

Fusion 360. The fusion files are included in the Printables link.

Short answer: saving leftover coffee. Edited in longer answer.

Short answer: saving leftover coffee. Edited in longer answer.

Short answer: saving leftover coffee. Edited in longer answer.