You need quite the opposite, more cooling on those overhangs. As you are in the chamber, the heated air wont cause warping like outside an enclosure, so crank those speeds on overhangs. I generally run 80-100% on bridges anf steep overhangs. I do also slow down print speed on overhangs significantly to allow more cooling aswell

May i see both of your works?? Id love to give em a read!

This would make so much more sense tbh, federating communities would also help bring the people who don’t quite ‘get’ the fediverse yet into coming onboard instead of being lost.

it sounds like you need to invert the runout sensor detection, as it is triggering immediately.