I ran a selftest and the manual test and the X-axis keeps failing. I don’t know why.
I tried:
Re-lubing
adjusting the X-axis belt
Adjusting the cables
I’ve had no luck with anything :/
Edit: I’ve watched a video and the extruder just hangs on the left side it for most the time it doesn’t go left then right, right aaway
Edit 2: I found the issue that I completely overlooked cuz I was annoyed…the bearing was sticking out somehow
Prusa machines come with phenomenal support, why not consult them directly?
Figured I’d make a post while I wait the 30 minutes
deleted by creator
Yup. And not sure if it matters either but x axis reads as 251
deleted by creator
I’m dumb, I found the issue…One of the bearings was sticking out Idk how I missed that especially looking stuff up ;-;
deleted by creator
Np lol. I honestly didn’t expect it, like it’s screwed down so how could it move? I love troubleshooting soooooo much
Was it a kit? Had it been printing before you started getting this issue or was this an issue out of the box?
Yep.